Table of Contents
Advertisement
Side effect
Warm feeling or tingling sensations during treatment,
which typically disappear after a few seconds to a
minute and decrease with continued use.
Discomfort or pain is intense during treatment or
persists after a treatment.
Skin redness during or after treatment which
disappears within minutes to several hours.
Skin redness which does not go away within
24 - 48 hours after treatment.
In very rare cases:
Swelling and redness around the hair follicle that
disappears within two or three days.
Swelling and redness around the hair follicle that
does not disappear within two to three days.
Temporary changes in skin color (lightening or
darkening).
Increase in hair growth in areas of treatment (more
likely to be seen with subjects of Mediterranean
descent).
Trouble shooting
The following troubleshooting guide may help you solving initial problems you may experience with this device.
Problem
Ready indicator (4) does not light up when
treatment window is placed on the skin.
Flashing sequence slows down.
Red ready indicator light
Red flashing indicator light
Ready indicator light flashes alternately red and
white.
The device is broken, cracked or appears
defective.
Disposal
The product contains recyclable electronic waste. To protect the environment, do not dispose of it
in the household waste, but take it to appropriate local collection points.
Subject to change without notice
How to assess and react
This is expected and normal for all IPL treatments.
You can keep on using the device as instructed.
Stop using the device and consult your physician
before using it again.
This is expected and normal for all IPL treatments.
You can keep on using the device as instructed
once skin redness has disappeared.
Stop using the device and consult your physician
before using it again.
You can keep on using the device as instructed
once swelling and redness around the hair follicle
has disappeared.
Stop using the device and consult your physician
before using it again.
If your skin color changes, stop using the device
and consult your physician.
If this increase persists over several treatments,
stop using the device and consult your physician.
Solution
Make sure the device is connected to an electrical
outlet. Press the treatment button to activate it.
Ensure that the entire treatment window area
touches the skin. If needed, move the device to
improve skin contact.
Device is in heat-protection mode. To get back to
normal speed, allow device to cool down.
Invalid skin tone reading. Your skin is either too
light or too dark. Device will not flash.
Device error. Device will not operate. Unplug and
reconnect. If error persists, contact a Braun
Service Centre for repair.
End of product lifetime. Maximum number of
flashes (300.000) has been reached.
Do not use if the handle, the base station or the
mains cord is damaged. If you are in any doubt
about the safety or suspect it is damaged in any
way, you must not use it.
17
Advertisement
Table of Contents
