Troubleshooting - Hisense AW1823TW3W Use And Installation Manual

Troubleshooting

Problem
Air conditioner will not operate
Air conditioner blows fuses or trips circuit breakers
Air conditioner power supply cord trips (Reset button pops out)
DANGER: ELECTRICAL SHOCK HAZARD
□ Plug into a grounded 3-prong outlet.
□ Do not remove ground prong.
□ Do not use an adapter.
□ Do not use an extension cord.
□ Failure to follow these instructions can result in death,
fire, or electrical shock
□ The power supply cord is unplugged. Plug into grounded
3-prong outlet. See "Electrical Requirements".
□ The power supply cord has tripped (RESET button has popped
out). Press and release RESET to resume operation.
□ A household fuse has blown, or circuit breaker has tripped.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician. See "Electrical Requirements".
□ The Power button has not been pressed. Press the Power but-
ton.
□ The local power has failed. Wait for power to be restored.
□ Too many appliances are being used on the same circuit. Unplug
or relocate appliances that share the same circuit.
□ Time-delay fuse or circuit breaker of the wrong capacity is be-
ing used. Replace with a time-delay fuse or circuit breaker of
the correct capacity. See "Electrical Requirements".
□ An extension cord is being used. Do not use an extension cord
with this or any other appliance.
□ You are trying to restart the air conditioner too soon after turn-
ing off the air conditioner. Wait at least 3 minutes after turning
off the air conditioner before trying to restart the air conditioner.
□ Disturbances in your electrical current can trip (RESET button
will pop out) the power supply cord. Press and release RESET to
resume operation.
□ Electrical overloading, overheating, cord pinching or aging can
trip (RESET button will pop out) the power supply cord. After
correcting the problem, press and release RESET to resume
operation.
A damaged power supply cord must be
NOTE:
replaced with a new power supply cord obtained from
the product manufacturer and must not be repaired.
22
Solution
.