Motorola MOTO BUDS 120 - Earbuds Quick Start Guide

Charging

Fully charge before use
The device can be powered through a USB-C from any CE compliant power source that implement the European interface as requested by EN 301 489-52.

Pairing

1. Ensure both buds are inside the charging case and take out both buds. The buds will flash blue and red.
   
   
2. Select "MOTO BUDS 120" from the smartphone bluetooth menu.

Fitting

1. To optimize the best fit and audio experience, it is recommended to try different earbud sizes.
   
   
2. Insert the MOTO BUDS into your ear and rotate to fit comfortably.
   

Basic Operation

Additional Operation

FCC and IC regulations (FCC Part 15)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
Industry Canada. This device complies with Industry Canada licenceexempt RSS standard(s): Operation is subject to the following Two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

Disposal of the Device (environment)
At the end of the product life cycle, you should not dispose of this product with normal household waste. Take this product to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user's guide and/ or box indicates this.
Some of the product materials can be re-used if you take them to a recycling point. By reusing some parts or raw materials from used products you make an important contribution to the protection of the environment. Please contact your local authorities in case you need more information on the collection points in your area.

European Union Directives Conformance Statement

The following CE compliance information is applicable to Motorola products that carry one of the following CE marks:
Hereby, MZGW declares that this product is in compliance with:

• The essential requirements and other relevant provisions of RED Directive 2014/53/EU
• All other relevant EU Directives
• The Declaration of Conformity can be obtained at motorolasound.com

UK Declaration of Conformity
Hereby, MZGW declares that this product is in compliance with the requirements for UKCA marking. The Declaration of Conformity can be obtained at motorolasound.com
Imported and distributed by: A.I.&E., Adriaan Mulderweg 9-11, 5657 EM Eindhoven, The Netherlands. Edco UK Ltd, 1st Floor, Two Chamberlain Square, Birmingham, B3 3AX, UK.

Model No.: MOTO BUDS 120
FCC ID: 2ARRB-VB120
Frequency Band: 2.402 – 2.480GHz
IC: 20353-VB120
Maximum RF power: 6 dBm
Working temperature: -10°C–45°C