Kidde KN-COP-DP-10YL-AQ-WF User Manual page 15

Indoor Air Quality Parameters
Visual
Air Quality
indications
Good
CO 50 PPM
Moderate
50 PPM
IAQ GOOD
Bad
IAQ MODERATE
70 F 80% H
Very Bad
ERATE IAQ BAD
0% H PRIOR CO 234 PPM IAQ xxx CO 0PPM
NOTE: The indoor air quality monitor may not react to some particles and its readings may be different
from that of other air quality measuring products and instruments.
O 234 PPM LOW BATTERY
CO 0PPM
Testing
Test your alarm weekly by pressing and releasing the Test/Hush button quickly. A quick beep will
CO 100 ppm
confirm the button has been pushed followed by the test sequence. See Other Alarm Visual and Audible
Indicators table. The alarm will sound if the electronic circuitry, horn, and battery are working. If the
alarm does not sound, or gives erratic or low volume sound, the unit must be replaced. See Permanently
0 ppm
REPLACE UNIT
Disable Alarm / Discharge Battery section to determine how to prepare the unit for shipment or disposal.
WARNING: DUE TO ThE LOUDNEss OF ThE ALARM, ALWAYs sTAND ABOUT 2.5 FEET
AWAY FROM ThE UNIT OR UsE EAR PROTECTION WhEN TEsTING.
E UNIT
CO TEST
WARNING: DO NOT UsE AN OPEN FLAME TO TEsT YOUR ALARM, YOU COULD
DAMAGE ThE ALARM OR IGNITE COMBUsTIBLE MATERIALs AND sTART A sTRUCTURE FIRE.
CO 50 PPM
TEST
Chirping
?
This unit samples the ambient light conditions of the alarm's location and, if possible, determines a Night /
0 PPM PROGRAMMING..
PROGRAMMING..
Day cycle. A valid Night / Day cycle will delay low battery, fault, and end of unit life chirps during the night
until the next Day cycle begins. When chirping begins during the next Day cycle, you can temporarily
silence Low Battery or End of Unit Life chirps Life by pressing the Test/Hush button. If a valid Night / Day
AMMING.. WIFI CONNECTING..
cycle has not been established because the unit is located in either a constantly dark or lighted location,
the chirps mentioned above will not be delayed at night. Moving the unit to a different location might
allow the unit to determine a valid Night / Day cycle.
WARNING: REPLACE UNIT As sOON As POssIBLE WhEN IN END OF UNIT LIFE OR LOW
BATTERY MODE.
Relative Humidity (%) Approx. VOC conc.
CO 50 PPM
30-50
IAQ GOOD IAQ MODERATE
25-30 or 50-60
IAQ MODERATE IAQ BAD
70 F 80% H IAQ xxx CO 0PPM
20-25 or 60-70
IAQ BAD IAQ VERY BAD
PRIOR CO 234 PPM IAQ xxx CO 0PPM
<20 or >70
IAQ VERY BAD
LOW BATTERY
CO 100 ppm
REPLACE UNIT
CO TEST
?
CO 50 PPM PROGRAMMING..
PROGRAMMING..
?
PROGRAMMING.. WIFI CONNECTING..
PROGRAMMING..
WIFI CONNECTING..
E R R O R
E R R O R
(ug/m^3)
<1,000
IAQ BAD IAQ VERY BAD
<3,000
IAQ VERY BAD
<10,000
>10,000
?
PROGRAMMING..
WIFI CONNECTING..
E R R O R
E R R O R
Temperature (F)
<=77 & >=64
>77 & <=79 or <64 & <=62
>79 & <=92 or <62 & <=48
>92 or <48
15