Advertisement
Quick Links
Advertisement
Summary of Contents for Wolf 18 Series
- Page 1 X18 MINI CRAWLER EXCAVATOR OPERATION & MAINTENANCE MANUAL MAXDUTY IMPORTS PTY LTD...
- Page 2 Operation joystick lock ● This device is to lock/unlock operation joystick. Please operate exactly according to instruction label on machine. Note 1.This device could not lock traveling joystick and extra line foot valve. They still work when the lock joystick Is pulled up。 2.When the lock joystick is pulled up, you cannot operate the working device...
- Page 3 Operation joystick instruction Left working device Right working device joystick joystick Left traveling Right traveling joystick joyst Accelerator knob Dozer blade joystick Flame out line Operation joystick lock swing/boom deflection switch joystick extra line foot valve...
- Page 4 Accelerator knob ● 1、Twist the knob clockwise to increase engine rotate speed. 2、When you shut down engine, twist the knob anticlockwise to the bottom slowly, decrease engine rotate speed gradually, DO NOT press the button on top and push knob down to bottom hardly to avoid knob failure.
- Page 5 Operation direction Left operation joystick Arm stretch out Arm withdraw Swing to left/boom deflect to left Swing to right/boom deflect to right Operation direction Right operation joystick Boom down Boom up Bucket dig Bucket dump Caution Please do not swing or deflection machine on slant road, otherwise there might be danger of turnover.
- Page 6 joystick and make sure it’s in lock position 3、If hydraulic oil’s temperature is low, the responsiveness of working device joystick will be slow, so please warm up the machine before work. 4.Please following below procedures before dismounting hydraulic attachments： ⑴Lower engine rotate speed, lay down the bucket on the ground ; ⑵Shut down the engine, move both sides working device joysticks to all directions;...
- Page 7 Swing Boom deflection Caution When work with boom deflection, keep people or barrier from boom deflection range to avoid injury. Dozer blade joystick ● To lift or lower dozer blade Push the joystick forward to lower dozer blade, pull the joystick backward to lift dozer blade.
- Page 8 extra line foot valve ● To operate hydraulic breaker or other attachments. After hydraulic breaker connected machine, raise upper pad to from, and step on right side of foot valve to proceed breaking. When using other attachments, step on left side of foot valve and hydraulic oil will flow to left side of arm, step on right side of foot valve and hydraulic oil will flow to right side of Safety belt...
- Page 9 seat forward, please put operation joystick lock to “lock” position, shut down the engine then proceed Work lamp/front Starter Gauge Horn switch lamp switch Starter ● To start the engine, insert key into starter, turn the key anticlockwise to first gear, all electrical circuits are opening and machine is preheated.
-
Page 10: Charging Indication
If the key is attached with metal key chain, it will hinder the signal transmission between key and switch to cause engine start failure. Horn ● When the key is on running position, press the horn switch and the horn will ring. Work lamp/front lamp switch ●... - Page 11 is stopped, put the key to running position the light will be turned on, and will go off after engine is started. If the light is still on after engine is started, please stop engine and check engine oil level. ◆Hour meter Indicate machine’s accumulate running hours.