Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Blade complete and Front handle (cont.)
ASSEMBLING
Take the disassembling step in reverse.
Note: Be sure to set Flat washer 8 and two Spindle sleeves in place. (Figs. 7 and 8)
Align the convex of Switch lever B with the depressions of L/R Housing set on the vertical lines, (Fig. 9) and then
fit their convex into their protrusions by enlarging Front grip portion carefully and shifting it. (Fig. 10)
Fig. 9
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Gear
DISASSEMBLING
1) Remove Blade complete, two Spindle sleeves, Flat washer 8 and Bush. (Refer to pervious page.)
2) Remove Gear and Spindle as an assembled part, and then remove Flat washer 8 between Gear and Bearing box complete.
(Fig. 11)
The assembled part can be disassembled as illustrated in Fig. 12 using 1R034 and arbor press.
Fig. 11
Bearing box
complete
Flat washer 8
an assembled parts
of Gear and Spindle
ASSEMBLING
Take the disassembling step in reverse.
Note: Be sure to pass Flat washer 8 through Spindle between Gear and Bearing box complete. (Figs. 11)
Spindle and Gear are directional. Refer to Figs. 13 and 14.
Fig. 13
Step of Gear
Spindle
depression of Housing R
protrusion on the right end of
Switch lever B
Align the depression of Housing L
with the protrusion on the left end
of Switch lever B in the same step.
Fig. 12
arbor press
Gear
1R034
Spindle
Fig. 14
Spindle
Flat surface
of Gear
1R034
Fig. 10
Enlarge both ends of Front handle
portion carefully.
Shift their ends to the fittings.
The assembled part
of Gear and Spindle
P 3/ 5
Advertisement
