Wireless kit for fdk series (fdk22~56, fdk71) (9 pages)
Summary of Contents for Mitsubishi Electric PAC-SNH21HB-E
Page 1
Compatib ble with uni its: PUHZ W80, SHW1 112, SHW1 PUHZ W100, SW12 PUHZ 25, P140 NOWHO OOD BA ACK KI PUHZ 125, SP140 25, P140 PTIONA AL PAR 25, P140 AC-SNH H21HB- stallati on Man nual afety Pr recautio •...
Page 2
sembly emble the snow hood d by follow wing the st eps in the assembly manual pr rovided aft er checking g all mponents ar re available Componen In a addition to this installa ation manu al, please c check the f following co omponents are include...
Page 3
Remove the left hand side screws holding the wire guard in position on rear panel. Create temporary mounting point for L Panel by loosening existing mounting screw (A) half way. 3 ...
Page 4
Mount L Panel using temporary mounting point. L Panel is mounted between rear panel and wire guard. When mounting L Panel ensure that the thermistor wire does not get caught between the panel and the unit, this will prevent the wire from being damaged. Refit wire guard screws taking care not to twist the guard when tightening.
Page 5
Screw mounting screw into side panel half way to create temporary mounting point for R Panel. 5 Mount R Panel using temporary mounting points. Loosely insert mounting screw into bottom and middle positions to align R Panel. With R Panel in ...
Page 6
move mountin ng screw from bottom Using Dr rill Screws cre eate mounting g holes in posi itions that hav ve been sition and then n remove R Pa anel. marked. . Discard dril ll screw afte r one use. ...
Page 7
sert mounting g screws halfw way into positi ons highlighte ed on L d R Panels to create tempo orary mountin g points for C CT Panel. Align slots s on CT Panel w with temporary mounting points on L and R Panels.
Page 8
Using drill screw create mounting hole in position that has been marked. Discard drill screw after one use. Remount CT Panel using existing mounting screws and screw supplied. 8 ...
Page 9
Mount CB Panel using temporary mounting positions on L and R Panels. Fully tighten mounting screws used for temporary mounting after the 9 lower screws have been tightened. ...
Page 10
Regular Checks/Maintenance Please check the following items regularly for safety: 1. Check if there is no loose screw on the snow hood and in the joints between the snow hood and the outdoor unit.