Table of Contents
Advertisement
3. Insert the pointed end of the spit rod into the
opening in the motor and rest the collar on the
frame (Fig. 13). The spit rod should freely turn
when the motor is turned on.
4. Figure 14 illustrates the spit rod correctly
installed.
Oven Setup
1. To use the unit as an oven, slide the wire oven
rack into the rails (Fig. 15).
NOTE: The wire oven rack must be installed
correctly. The correct installation is with the
lowest side of the heat deflector near the
burner.
Burner and Orifice
1. Proper location of the burner with respect to the
venturi and orifice fitting is important. To verify
the proper factory installation of the burner and
venturi, look at the unit from below and locate
the burner and venturi. The burner inlet must
be located in line with the venturi and the
orifice fitting on the end of the fuel tube
(Fig. 16).
Fig. 13
■ Check and clean the burner/venturi tubes for
insects and insect nests. A clogged tube can
Fig. 14
lead to a fire beneath the appliance.
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the outdoor rotisserie until
connection has been leak tested and does
not leak.
• Keep all connections and fittings clean.
Inspect propane cylinder and rotisserie
propane connections for damage before
attaching.
• During set up, check all connections and
Fig. 15
fittings for leaks using soapy water. Bubbles
indicate a leak. Never use a flame to check
for leaks.
English-8
Infra Red Burner
Venturi
Orifice Fitting
Leak Testing
WARNING
CAUTION
• SERVICE SAFETY
Fig. 16
Advertisement
Table of Contents
