Connecting To Another Pc In Ad-Hoc Mode; How To Configure An Ad-Hoc Mode Profile - NETGEAR WAG311 Installation Manual

Dual band wireless pci adapter

Hide thumbs Also See for WAG311:

Table of Contents

Installation Guide for the NETGEAR Dual Band Wireless PCI Adapter WAG311

4. Verify wireless connectivity to your network.

Verify connectivity by using a browser such as Netscape or Internet Explorer to connect to the

Internet, or check for file and printer access on your network.

You can check the status bar in the configuration utility for the current connection status.

Note: If you cannot connect, see the

have problems accessing network resources, the Windows Client and File and Print Sharing

software might not be installed and configured properly on your computers. Please refer to

"Preparing Your Computers for TCP/IP Networking" on page

Connecting to Another PC in Ad-Hoc Mode

The computer-to-computer setting of the WAG311 uses Ad-Hoc mode. Ad-Hoc mode is an 802.11

networking framework in which devices or computers communicate directly with each other,

without the use of an access point. For example, this mode is used when two Windows computers

are configured with file and print sharing enabled and you want to exchange files directly between

them.

Note: Ad-Hoc mode will not work using DHCP settings. Ad-Hoc mode requires either static IP

addresses (such as

192.168.0.1)

parameters such as adding IPX protocol support. For instructions on setting up static IP addresses

or IPX protocol settings on a Windows PC, refer to the PC Networking Tutorial included on the

NETGEAR Dual Band Wireless PCI Adapter WAG311 Resource CD (SW-10015-01).

Follow the instructions below to configure an Ad-Hoc mode profile.

1. Run the WAG311 Configuration Utility.

Open the configuration utility by clicking on the WAG311 icon

system tray.

Configuration

"Basic Troubleshooting Tips" on page

or other appropriate Windows networking configuration

2-14. Also, if you

C-1.

in the Windows

3-5

Table of Contents