Compliance Information - NETGEAR FA310TX Installation Manual

Compliance Information

© 2000 by NETGEAR, Inc. All rights reserved.
Trademarks
NETGEAR™ is a trademark of NETGEAR, Inc. Windows® is a registered
trademark of Microsoft Corporation. Other brand and product names are
trademarks or registered trademarks of their respective holders. Information is
subject to change without notice.
Statement of Conditions
In the interest of improving internal design, operational function, and/or
reliability, NETGEAR reserves the right to make changes to the products
described in this document without notice.
NETGEAR does not assume any liability that may occur due to the use or
application of the product(s) or circuit layout(s) described herein.
Certificate of the Manufacturer/Importer
It is hereby certified that the Model FA310TX Network Card has been
suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg
243/1991 and Vfg 46/1992. The operation of some equipment (for example, test
transmitters) in accordance with the regulations may, however, be subject to
certain restrictions. Please refer to the notes in the operating instructions.
Federal Office for Telecommunications Approvals has been notified of the
placing of this equipment on the market and has been granted the right to test the
series for compliance with the regulations.
Federal Communications Commission (FCC) Compliance Notice: Radio
Frequency Notice
Note: Modifications to this device change it from the original state it
was in when tested and may alter the device so that it no longer
complies with FCC testing limitations for Class B digital devices.
According to FCC regulations, the user could be prohibited from
operating this equipment if it is modified.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may causeundesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
Model FA310TX Network Card Installation Guide