NETGEAR WNR2000 Setup Manual page 18

Review that your network is now set up (as shown in
8.
network.
Figure 10
Start your network in the correct sequence, as described below.
9.
Failure to start or restart your network in the correct sequence could prevent you
from accessing the Internet.
To start your network:
Plug in and turn on the cable or DSL modem. Wait 2 minutes.
1.
2. Plug the end of the power adapter's cord into the wall or a power strip, and into the power
adapter outlet of your wireless router (F). Wait 1 minute.
14
Figure 10); you are ready to start your
Manually Installing Your Router