Computers Set To Dhcp; Manually Setting Up Your Wireless Adsl Modem Router - NETGEAR RangeMax DG834N Setup Manual

Wireless ADSL2+ Modem Router Setup Manual
ADSL Microfilter with Built-In Splitter
ADSL
Pho ne
Figure 1-4
Use an ADSL microfilter with built-in splitter when there is a single wall outlet which must
provide connectivity for both the wireless ADSL modem router and telephone equipment.

Computers Set to DHCP

For the initial connection to your router, your computer has to be set to automatically get its
TCP/IP configuration from the router via DHCP. This is usually the case. The NETGEAR Smart
Wizard CD automatically takes care of this requirement. For manual setup, refer to the
documentation that came with your computer.

Manually Setting Up Your Wireless ADSL Modem Router

There are four steps to setting up your wireless ADSL modem router:
1. Install ADSL filters on the phone lines.
2. Connect the router to the ADSL line.
3. Log in to the router.
4. Connect to the Internet.
Follow the steps below to connect your router to your network. Before you begin, locate the ADSL
configuration information from your Internet Service Provider (ISP).
1. Connect the ADSL filter.
Note: If you purchased the DG834N in a country where an ADSL filter is not
included, you must acquire one.
Connecting the Router to the Internet 1-7
v1.0, 2006-4