Table of Contents
Advertisement
Starting the Machine
1.
Ensure that the battery-pack is connected to
the machine.
2.
Ensure that the battery-disconnect switch is in
the ON position.
3.
Stand on the platform.
4.
Ensure that the loader-arm/attachment-tilt lever
and traction control are in the N
5.
Insert the key into the key switch and turn it to
the O
position.
N
Note:
The machine may have difficulty starting under
severe cold conditions. When starting a cold machine,
keep the machine above -18°C (0°F).
Note:
When the machine temperature is below
-1°C (30°F), the cold-start symbol will appear on the
InfoCenter while the hydraulic fluid warms. Hydraulic
function may be reduced during this time. The
cold-start symbol disappears when the fluid is warm.
Figure 14
Shutting Off the Machine
1.
Park the machine on a level surface and lower
the loader arms.
2.
Disengage the auxiliary hydraulics.
3.
Ensure that the loader-arm/attachment-tilt lever
and traction control are in the N
4.
Turn the key switch to the O
remove the key.
Note:
The parking brake engages automatically
when you stop the machine and release the traction
control to the N
EUTRAL
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key when leaving the
machine unattended.
Sleep Mode
After 30 seconds of inactivity, the machine goes into
sleep mode and displays the sleep mode icon on
the InfoCenter. Hydraulics and traction controls are
disabled during sleep mode.
position.
EUTRAL
position.
EUTRAL
position and
FF
position.
To resume normal operation, rapidly move the traction
control twice.
After 5 minutes, the machine shuts off; cycle the key
to start the machine again.
Using Attachments
Installing an Attachment
Important:
Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the machine. The
warranty of the machine may be voided if you use
the machine with unapproved attachments.
Important:
Before installing the attachment,
ensure that the mount plates are free of any dirt or
debris and that the pins rotate freely. If the pins
do not rotate freely, grease them.
1.
Position the attachment on a level surface with
enough space behind it to accommodate the
machine.
2.
Start the machine.
g304012
3.
Tilt the attachment mount plate forward.
4.
Position the mount plate into the upper lip of the
attachment receiver plate.
1. Mount plate
5.
Raise the loader arms while tilting back the
mount plate at the same time.
Important:
clear the ground and tilt the mount plate all
the way back.
6.
Shut off the machine and remove the key.
7.
Engage the quick-attach pins, ensuring that they
are fully seated in the mount plate.
Important:
engaged position, the mount plate is not
fully aligned with the holes in the attachment
18
Figure 15
2. Receiver plate
Raise the attachment enough to
If the pins do not rotate to the
g003710
Advertisement
Table of Contents
