Removing The Lcd Monitor And Lcd Attachment Unit - Canon EOS C300 Mark III Manual

Preparing the Handle Unit and LCD Monitor
NOTES
• Based on the LCD monitor's position, you can invert the image displayed on the screen. Repeatedly pressing
the MIRROR button will change the displayed image in the following order: Image inverted horizontally 
32 Image inverted vertically  Image inverted horizontally and vertically  Original image.
• You can adjust the brightness, contrast, color saturation, sharpness and luminance of the LCD screen with the
respective settings in the
• In CAMERA mode, you can use the
change the LCD monitor to black and white display. Even when the captured image is displayed in black and
white, onscreen displays and icons will be shown in color.
• You can use the
response to touch input.

Removing the LCD Monitor and LCD Attachment Unit

1 Turn off the camera.
2 Disconnect the unit cable from the camera's and
monitor's VIDEO terminals.
• Pull back the metallic tip of the plug and then
disconnect the cable from the terminal.
3 Loosen the locking knob and remove the LCD
attachment unit and monitor.
IMPORTANT
• Be careful not to drop the camera when attaching or
removing the LCD monitor.
NOTES
• If the LCD attachment unit's locking knob was fastened
very tight, you may need to use the supplied hex wrench
for 0.64 cm, 1/4" screws to loosen it.
> [¢ Monitoring Setup] menu (A 193).
> [¢ Monitoring Setup] > [B&W Image: VIDEO Term.] setting to
> [B System Setup] > [Touch Screen Response] setting to adjust the LCD monitor's