Advertisement
Quick Links
Set up and operating inStructionS
Visit our website at: http://www.harborfreight.com
read this material before using this product.
Failure to do so can result in serious injury.
SaVe thiS Manual.
Copyright
2005 by Harbor Freight Tools
©
contained herein may be reproduced in any shape or form without the express written consent of
Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product described herein. Tools required for
assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
Manual revised 10d
Solar-powered
Security light
Model
. All rights reserved. No portion of this manual or any artwork
®
93661
Advertisement
Summary of Contents for Harbor Freight Tools 93661
- Page 1 Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
- Page 2 Ni-Cd batteries must be disposed of replacement parts. Use of any other properly. Do not incinerate. Batteries parts will void the warranty. may burst, causing personal injury and/ reV 09j Page 2 For technical questions, please call 1-800-444-3353. SKU 93661...
-
Page 3: Table Of Contents
Security Light, check to make sure parts on page 8 are included. If any parts are missing or broken, please call harBor Freight toolS at 1-800-444-3353. Hinged Mounting Bracket (8) Figure 1 reV 09j, 10d SKU 93661 For technical questions, please call 1-800-444-3353. Page 3... - Page 4 Figure 4 b. Remove the Mounting Bracket (13) from the Lamp (1) by unscrewing the two screws where it connects to the Lamp (1). reV 06g, 09j, 09k, 10d Page 4 For technical questions, please call 1-800-444-3353. SKU 93661...
- Page 5 To adjust it up or down, first loosen the solar Panel to the Lamp (1) and plug it Dial counterclockwise, adjust the Head, into the outlet on the battery housing. then tighten the Dial clockwise. reV 10d SKU 93661 For technical questions, please call 1-800-444-3353. Page 5...
- Page 6 3 dayS oF Full Sunlight to fully charge the batteries. Switch ON Power ON Figure 11 After charging, turn the Power Switch ON. The light will illuminate for a short reV 09j, 09k, 10d Page 6 For technical questions, please call 1-800-444-3353. SKU 93661...
- Page 7 2 the minimum and maximum settings to minutes after motion is achieve the desired level of sensitivity. no longer detected. rev 06g; 08h; 09j, 10d SKU 93661 For technical questions, please call 1-800-444-3353. Page 7...
- Page 8 If the light is over-activated by small animals or rapid changes in heat, the sensitivity can be reduced by turning the knob counterclockwise towards the minimum setting (“-”) Maximum position rev 06g; 09j, 10d Page 8 For technical questions, please call 1-800-444-3353. SKU 93661...
-
Page 9: Power Switch
Battery Housing Cover Battery Pack Connector Battery Pack Figure 17 Pull the back of the Housing away from the Housing, being careful to keep the wire connections from straining. reV 10d SKU 93661 For technical questions, please call 1-800-444-3353. Page 9... - Page 10 If oil gets on the new bulb, remove the bulb, clean with rubbing alcohol, and reinstall. Close the hinged cover and secure with the screw. reV 10d Page 10 For technical questions, please call 1-800-444-3353. SKU 93661...
- Page 11 Reposition the Motion Detector Head (6). Sudden temperature change Turn Power Switch “OFF” until storm passes. due to storms or high winds. Mount in a sheltered location. reV 10d SKU 93661 For technical questions, please call 1-800-444-3353. Page 11...
-
Page 12: Mounting Bracket
TIME Adjusting Knob 6 Volt-10 Watt Quartz Bulb NiCd 6V Battery Pack (not shown) Battery Housing Mounting Bracket Motion Detector Head 9, 10, 11 Front View Side View reV 08h, 10d Page 12 For technical questions, please call 1-800-444-3353. SKU 93661...