Table of Contents
Advertisement
Troubleshooting
If the system displays any of these
actions, adjustments may be necessary
to restore performance. Contact Polaris
Customer Service at 1-800-822-7933 for
further information.
Action:
Service light is lit and
display shows "91."
Solution:
1. Check water temperature and
2. Press Test button for
3. Visually inspect cell and clean
Action:
Display shows "92" and Flow
light is not lit.
Solution:
1. Confirm circulation pump in
2. Clean skimmer, filter and
3. Inspect cell and clean.
4. Verify valve to cell
5. Check cell installation; arrows
6. Verify flow switch wires are
Action:
Display shows "94."
Solution:
1. Check salt level. Fault code
2. Possible cut cell cord.
verify that it matches
temperature setting on
controller. Correct temp.
setting if necessary.
current salt concentration.
Add salt as needed.
if necessary.
running.
pump basket; backwash
if necessary to ensure flow.
is open.
on flow switch and cell
housing should point in
direction of flow.
connected and intact.
may indicate salt level is
below 1500 ppm.
www.polarispool.com
Action:
Power light is not lit and
display is dark.
Solution:
1. Check circuit breaker and
reset if needed.
Action:
Test button salt reading and
Eos (other controller) salt
readouts don't match.
Solution:
1. Manually test for salt level
and adjust to attain 3000-
3500 ppm.
Action:
AutoCycle and Sanitizing lights
don't come on in normal or
boost mode.
Solution:
1. Press the Restart and
Text buttons simultaneously
to reset.
Advertisement
Table of Contents
