Coleman Tent 919A162 Instructions

Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your Beach Shade.
WARNING: Keep clear of overhead power lines.
• Do not set up your Beach Shade under trees.
• For best results in windy conditions, position end of Beach
Shade into the wind.
• Enlist the help of at least one other person to assist you when
it is time to assemble the Beach Shade.
Parts and Components
Description
Main Poles - Black (2)
Crossover Pole - Gray (1)
Main Poles (2)
Crossover Pole (1)
To Set Up Beach Shade
1. Unfold Beach Shade and spread out on a clean, level surface
with the door facing the desired direction. Unzip door.
(Fig. 1)
2. Stake down shade corners,
using the outside grommets on
the web straps. Keep the floor
taut. (Fig. 2)
Option: Use sand bags to weight
shelter down, see Fig. 15 & 16.
3. Assemble both Main (black) Poles and the Crossover (gray)
Pole by interlocking shock-corded poles.
4. Insert the Main (black) Poles through the pole sleeve running
side to side. (Fig. 3)
5. Insert the Crossover (gray) Pole through the pole sleeve
running side to side. (Fig. 3)
Gray Pole
BEACH SHADE
Part Number
9192-902
9192-922
Fig. 2
Black Poles
TM
MODEL 9192A162
To Set Up Beach Shelter
6. Insert one end of the gray Crossover Pole into the grommet
on the web strap on either side of front door. (Fig. 4)
7. Go to opposite end of the gray pole and gradually apply
pressure to the pole, forming an arch, until you are able to
insert the pole tip into the grommet on the web strap. (Fig. 5)
Fig. 5
8. Go to the back of the
Beach Shade and
insert black Main Pole
tip into the grommet
on the web strap.
(Fig. 6)
Fig. 1
9. From the front of the Beach Shade, gently pull the black Main
Pole down until you
can insert the end into
the grommet on
the web strap located
above the door open
ing. (Fig. 7)
10. Repeat for the
second black
Main Pole.
(Fig. 8)
Fig. 3
(continued)
(continued on other side)
Fig. 4
Fig. 6
Fig. 7
Fig. 8