Included In The Package; Getting Started; Battery Removal And Installation - VTech Switch&Go Dinos Eggs T-Rex Instruction Manual

INCLUDED IN THE PACKAGE

Switch & Go Dinos
•
• 15 Pieces for Assembly
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child's safety.
NOTE
Please save this Instruction Manual as it contains important information.

GETTING STARTED

Exit Try-Me Mode:
The product is in Try Me mode in the packaging. To exit try-me
mode, just slide the "Off/Dino Mode/Vehicle Mode" Switch from
Vehicle mode to Dino mode/Off.

Battery Removal and Installation

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the unit. Use a screwdriver to loosen the
screw and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling up
on one end of each battery.
4. Install 1 new AAA (AM-4/LR03) battery
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the
screw to secure.
Eggs T-Rex
®
4