Cushions; M8 × 18 Mm; M4 × 10 Mm - NEC PX-SP4U/B Instruction Manual

Attaching speakers to a
The speakers are divided into a right (R) and left (L) speaker.
When attaching the speakers, be sure to check the labels located on the rear of the speakers as well as the markings (R/
L) written on the attachment plates.
1
Remove the protective tape from the cushions and then
attach the cushions to the sides of the speakers in the
locations indicated in the diagram below.
3
Screw the M8 x 18 mm screws loosely into the screw holes
at the upper end of the plasma monitor (2 locations).
∗
Illustration shows an example using a 42-inch
monitor.
42 50
-inch or -inch plasma monitor

Cushions

M8 × 18 mm
2
Place the speakers as indicated in the diagram below.
(Orient speakers so that the speaker jacks come towards
the bottom of the diagram.)
Attach the attachment plates marked 'R' to the speaker
with the label marked 'R'. Place the attachment plates onto
the speakers so that the guide pins are inserted into the
holes in the attachment plates as indicated below, and fix
the plates tightly into position using the M4 x 10 mm screws
(8 screws).
M4 × 10 mm
R
R
Speaker jacks
Guide pins
4
1 Place the attachment plates at the upper part of the
speakers over the screws at the top of the plasma
monitor.
2 Align the holes of the attachment plates of the speakers
over the screw holes located at the bottom of the plasma
monitor and use the M8 x 18 mm screws to loosely
tighten into place (2 locations).
R
R
R
R
R
4
L
L
Speaker jacks
R
L
L
L
L