Toshiba L64 Digital Series User Manual page 19

v
Press B / b to move through the list to select a
channel, and then press OK to view.
In ATV mode, some areas may receive duplicate
stations. There may not be a clear picture or the
signal may be weak, so the station order can be
changed using ATV Manual Tuning.
REMEMBER: Press TV at any time to select
between ATV and DTV modes.
NOTE: The time will be set automatically by
transmission but can be advanced or decreased
by using Local Time Setting in the DTV Settings
screen.
w
Select Next and press OK. The Satellite Settings
screen will appear. From this window, you can add
the satellites that you wish to tune and configure
detailed settings for each one individually.
Select Switch Type and choose the correct switch
configuration for your satellite dish from the
settings None, ToneBurst, DiSEqC 2way,
DiSEqC 4way or Single cable.
Satellite Settings
Switch Type
LNB Power
No. Satellite
1 Astra 19.2E
2
3
4
Done
NOTE:
• None is being used when the satellite dish will
control only one universal Low Noise Block
(LNB) with a single satellite (e.g. Astra 19.2°). As
a rule, most households use just one satellite.
• ToneBurst controls the ToneBurst switch.
It is able to switch two LNBs automatically.
• DiSEqC 2way automatically switches between
two LNBs, which receive different satellites at the
same time (e.g. Astra 19.2° and Hotbird 13°).
• DiSEqC 4way automatically switches between
up to four LNBs / satellites.
• Single cable is selection and control of plural
Satellite antennas through the combined single
antenna cable.
None None
On ToneBurst
LNB DiSEqC 2way
Dish
1 1 DiSEqC 4way
Single Cable
The setting LNB Power enables you to switch on
or off the LNB's power supply by means of the TV.
When your satellite dish consists of only one LNB,
LNB Power should generally be activated (On).
When using more than two LNBs, it is
recommendable to use external power supply for
these.
Satellite Settings
Switch Type
LNB Power
No. Satellite
1 Astra 19.2E
2
3
4
It is possible to select up to four satellites. Please
note that the number of available LNBs and the
adjustment of your satellite dish determines the
number of satellites found. For example, it is not
possible to receive more than one satellite if your
dish is directed to a single satellite. For further
information on satellite signal technology, please
contact your local dealer.
Satellite Settings
Switch Type
LNB Power
No. Satellite
1 Astra 19.2E
2
3
4
Transponder : 1/120 (10729) MHz
Dish Type : Fixed
Lower LOF : 9750
Upper LOF : 10600
Once you have selected a satellite, you can
change further settings under Dish and LNB.
Press OK and
press GREEN button.
Under Dish you choose the dish type that will be
used (fixed or moveable dish). The majority of
households have a fixed satellite dish.
19
SETTING UP YOUR TV
None
On
On
LNB
Dish Off
1 1
Done
None
On
Dish LNB
1 1
Done
C / c to select Dish or LNB and