HoMedics THERAPIST SELECT PRIME Instruction Manual And Warranty Information page 4

INSTRUCTIONS FOR USE
1. Your massager, when opened, may require charging. To charge your
massager, plug one side of the USB-C cord into the unit and plug the
other end into an adapter. Next, plug the adapter into a 120-volt outlet.
Your massager will be fully charged after a minimum of 5 hours charge
time, and the charge will last up to 2 hours 30 minutes.
NOTE: This device only comes with a USB-C cord, not an adapter. A
USB-C phone charger will also charge the unit. The unit will not operate
when it is charging. Use a 5V2A (or 5V/1A, slower) charger, but can not
be higher than 5V.
2. To turn the massager on, press and hold the power p button for 2 seconds. The battery LED light
indicators will illuminate to confirm the unit is on.
3. Press the power p button once to begin the massage and continue to press (up to 5 times) to
increase intensity (Fig. 1). Once through intensity cycle, press again to stop the percussion motion
and again to resume on low intensity.
4. Apply the massage head to the muscle you would like to massage.
5. When the massage is complete, turn the unit off by pressing and holding the power p button for
2 seconds. The unit is off when all LED lights turn off.
CAUTION: NEVER use this appliance on or near eyes or other highly sensitive areas.
NOTE: This unit is equipped with a 15-minute auto-off feature for your safety.
BALL ATTACHMENT
Perfect for all-over body use. This attachment can be
used on small and large muscle groups.
4
Fig. 1