NEC NP43 User Manual page 28

Selecting Default Source
You can set a source as the default source so that the default source will be displayed each time the projector is
turned on.
1. Press the MENU button.
The menu will be displayed.
2. Press the ▶ button twice to select [SETUP] and press
the ▼ button or the ENTER button to select [GENERAL].
3. Press the ▶ button three times to select [OPTIONS(2)].
4. Press the ▼ button six times to select [DEFAULT
SOURCE SELECT] and press the ENTER button.
The [DEFAULT SOURCE SELECT] screen will be dis-
played.
(→ page 74)
5. Select a source as the default source, and press the
ENTER button.
NOTE: To specify [VIEWER] as the default source on the NP64
or NP54, select [VIEWER] from the [DEFAULT SOURCE SELECT]
screen, and press the ENTER button because detecting the signal
automatically is not available for the Viewer source on the NP64
and NP54.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
The source you selected in step 5 will be displayed.
TIP: When the projector is in Standby mode, applying a computer
signal from a computer connected to the COMPUTER IN input will
power on the projector and simultaneously project the computer's
image.
([AUTO POWER ON(COMP.)] → page 73)
3. Projecting an Image (Basic Operation)
NP63/NP43
NP64/NP54
19