Table of Contents
Advertisement
Telephone Connection Requirement
A plug and jack is used to connect this equipment to the premises wiring and
telephone network must comply with the FCC Part 68 rules and requirements
adopted by the ACTA.
A compliant telephone cord and modular plug is provided with this product
which is designed to connect to a compatible Standard Modular jack.
Connection to the telephone network should be made by using standard
modular telephone jacks, type RJ-11C. The RJ-11C plug and/or jacks used
must comply with the FCC Part 68 rules.
CIRCUIT TYPE
LOOP START
LINE
DID LINE
E & M TIE LINE
Ringer Equivalence Number
The REN is used to determine the number of devices to be connected to a
telephone line. If the total allowable REN load is exceeded, the phone circuit
may fail to ring. In most cases, the total REN for a telephone line should not
exceed Five (5).
Contact Local Telephone Company, to be certain about the number of devices
connected to a line, which is determined by the total REN.
For earlier products, the REN is separately shown on the label.
© SAMSUNG Electronics Co., Ltd.
FACILITY INTERFACE
MODULE TYPE
FXO
02LS2
T1E1
04DU9.DN
04DU9.1KN
04DU9.1SN
04DU9.1SN (PRI)
FXS
02RV2.T
T1E1
04DU9.BN
T1E1
04DU9.BN
Ubigate iBG1003 Installation Manual/Ed.04
CODE
NETWORK
JACK
RJ11C
RJ48C
RJ11C
RJ48C
RJ48C
III
Advertisement
Table of Contents
