*15G062394001AK*
P/N: 15G062394001AK V1.1
With ASRock 13.3" Side Panel Kit, you can easily build a LCD display inside
your PC case, which provides you with a sub screen for monitoring PC status
or allows you to send messages, watch videos or do streaming at the same time.
This IPS panel equipped with eDP interface reduces power consumption and
meanwhile delivers great viewing experience.
Before You Begin
•
Please make sure your PC case contains a transparent tempered glass side
panel, with enough space to mount the eDP panel. Use the microfiber
cloth to wipe the panel clean and identify the location you want to mount
your screen.
Note: The transparency of your side panel may affect the display quality of your eDP panel.
•
Make sure the motherboard of your system comes with an eDP connector.
Please visit ASRock's website for the supported motherboards with eDP
interface.
Installation Procedure
The illustrations in this guide are for reference purposes only and may not exactly match the model
you purchase.
1. Gently lift the 13.3" eDP screen panel, along with the two long brackets, from
the box. Remove the brackets from both sides of the eDP panel.
ATTENTION! Two brackets are not clung to the panel. Beware of
dropping the panel when you remove them.
2. Take out two mounting brackets and two retaining rubber strips from the
box. Both are required for either the vertical or the horizontal display.
Note: For vertical display, we suggest you rotate the PC side panel 90 degrees during installation.
Once the eDP panel is securely attached with the brackets and the rubber strips, rotate the PC
side panel back to normal postion.
Vertical Display
Rubber
eDP Panel
Rubber
B
A
Horizontal Display
Bracket
eDP Panel
Bracket
Package Contents
13.3" eDP Panel
Specification
Panel Size (inch): 13.3
•
Aspect Ratio: 16:9
•
Display Viewing Area (H x V):
•
93.76 x 165.24
Display Surface: Anti-Glare
•
Backlight Type: LED
•
Panel Type: IPS
•
Pixel Pitch: 0.153mm
•
*For the updated and more information, please visit www.asrock.com.
3. Take one bracket. Peel the blue plastic liner off. Do not touch the adhesive
surface.
Note: Do not peel off the black strip behind the blue plastic liner. The black strip allows you to
easily remove the bracket.
Black Strip
Blue Plastic Liner
4. Paste the bracket to the desired location on the internal side of the PC side
panel. Press and hold the bracket for a few seconds to ensure adhesion. Be
sure to leave enough space above, allowing the eDP panel to be placed.
F r e e S
p a c e
Dimensions of the 13.3" eDP Panel
with Brackets and Rubbers Installed
320.26mm
2 x Rubber Strips
2 x Brackets
5 x Cable Clips
eDP Cable
Resolution: 1920 x 1080
•
Brightness (Typ.): 300 cd/m2
•
Contrast Ratio (Typ.): 800:1
•
Display Colors: 16.7M (8 bit)
•
Refresh Rate (Max): 60 Hz
•
Dimension (W x H x D):
•
300.3 x 177.6 x 2.3 mm
Transparent Side Panel