Hps1000 Specifications - Infinity HPS1000 Technical Manual

Amplifier/Subwoofer
Frequency response
Drive unit
Weight
Dimensions
LINE VOLTAGE
US 120vac/60Hz
EU 230vac/50-60Hz
Parameter
Amp Section
Type (Class AB, D, other)
Load Impedance (speaker)
Rated Output Power
THD@ Rated Power
THD @ 1 Watt
Polarity
DC Offset
Damping factor
Input Sensitivity
Input Frequency
Line Input
Speaker/Hi Level Input
Signal to Noise
SNR-A-Weighted
SNR-unweighted
SNR rel. 1W-unweighted
Residual Noise Floor
Residual Noise Floor
Input Impedance Line Input
Speaker/Hi Level Input
Active Filters
Low Pass (fixed or variable)
Low Pass filter (point or range)
Slope
Normal-Direct Switch
Low Pass filter (point or range)
Slope
Subsonic filter (HPF)
Slope
Video Boost Switch
Boost
Range
Limiter
Features
Phase Switch (yes/no)
Line Output (80Hz HPF-unity gain)
Volume pot Taper (lin/log)
Input Configuration
Line In (L,C,R,AC3,Mono)
Spkr/Hi Level In
(L,C,R,mono)
Line Outputs (L,C,R)
Line Out Crossover Switch
Line Out: 80/120/160Hz HPF
Slope
Hi Level Out
Power on Delay time
Transients/Pops
ATO Transient
Turn-on Transient
Turn-off Transient
Efficiency
Stand-by Input Power
Efficiency
Protection
Thermal Protection
DC Offset Protection
Line Fuse Rating

HPS1000 SPECIFICATIONS

18Hz - 150Hz
15" Woofer (2) 15" Passive Radiators
96lbs/43.5kg
21 7/8 x 20 7/16 x 23 13/16" (556 x 519 x 605mm)
Specification Unit
AB Bridged --
7 Ohms
1000 Watts
0.8 %
0.5 %
0 deg.
20 mV-DC
>200 DF
27 Hz
350 mVrms
7.4 Vrms
100 dBA
70 dBr
60 dBr
2 mVrms
1.5
mVrms(max)
3k ohms
470 ohms
Variable
45-120 Hz
12 dB/Octave
Q -- Damping
yes --
160 (direct)
45-120 (normal)
Hz
12 dB/Octave
Q -- Damping
27 Hz
12 dB/Octave
Q -- Damping
yes --
+3 dB
40-80 Hz
yes
--
yes --
yes --
log --
-- --
L,R --
L,R --
L,R --
yes
80/120/160 Hz
6 dB/Octave
Q 0.707 Damping
yes --
>3 sec.
10
mV-peak
500 mV-peak
500 mV-peak
10 Watts
#REF! %
yes
yes
6 Amps
Limits Conditions
-- BASH® Power Supply
-- Nominal
900 1 input driven
1 22k filter
1 22k filter
0 ±20 ° In phase at 50Hz in Direct Mode
50
@ Speaker Outputs
-- @700w/27Hz
27 Nominal Freq.
±2dB 800w ref.
±2dB
800w ref.
90 relative to rated power
70 relative to rated power
55 relative to 1W Output
3 Volume @max, using RMS reading DMM/VOM (or A/P)
2 Volume @max, w/ A/P Swept Bandpass Measurement (Line freq.+ harmonics)
N/A
N/A
Note: Center positon = 100Hz
±2dB
n/a
n/a
functional
±2dB
--
--
±2dB
--
--
--
±1dB
--
functional
functional
functional
functional
functional
functional
functional
functional
functional
functional
>3 AC Power Applied
20
@ Speaker Outputs
1v-pp @ Speaker Outputs
1v-pp @ Speaker Outputs
15 @ nom. line voltage
70 @ nom. line voltage
functional
functional DC present at Speaker Out leads
functional Type-T or Slo Blo
HPS1000
Notes
Z-curve required
500w
.250 faston (+)......205 faston (-)
1 input driven
1 input driven
1 input driven
A-Weighting filter
22k filter
22k filter
Z-out=10k: Use 100k load for testing
Loop through for L,R Hi Level Inputs
AC Line cycled from OFF to ON
AC Line cycled from ON to OFF
800w ref..
Decreases gain at 113 C -1.3dB °
Relay or crowbar (for driver/fire protection)
3