Preparing To Install The Processor Heatsink Module (Phm) Into The Cpu Socket - Supermicro X12DPi-N6 User Manual

Super X12DPi-N6/X12DPi-NT6 User's Manual
Preparing to Install the Processor Heatsink Module (PHM) into
the CPU Socket
After assembling the Processor Heatsink Module (PHM), you are ready to install it into the
CPU socket. To ensure the proper installation, please follow the procedures below:
1. Locate four threaded fasteners (a, b, c, d) on the CPU socket.
d
(a, b, c, d: Threaded Fasteners)
2. Locate four PEEK nuts (A, B. C. D) and four rotating wires (1, 2, 3, 4) on the heatsink
as shown in the graphics below.
A, B, C, D: Peek Nut
1, 2, 3, 4: Rotating Wire
a, b, c, d: Threaded Fastener
Rotating Wire
Peek Nut
(Unlatched)
3. Check the rotating wires (1, 2, 3, 4) to make sure that they are at unlatched positions as
shown in the drawing below before installing the PHM into the CPU socket.
Unlatched State
PEEK Nut
CPU Socket
b
c
a
4
Rotating Wire
D
d
(latched)
CPU Socket
Rotating Wire
32
Threaded Fastener
CPU Socket Pin1
Heatsink (Reverse Side)
B
2
Rotating Wire
C
Rotating Wire
A Peek Nut
b
c
a
Threaded Fastener
Top View
Side View
3
1