Sony DSX-A410BT Service Manual page 20

DSX-A410BT/A415BT
Ver. 1.1
(DSX-A410BT: E, AR, IND, AUS)
Power connection diagram (Argentine
models only)
Make sure your car's auxiliary power connector, and
match the connections of cords correctly
depending on the car.
Auxiliary power connector
Common connection
Red Red
Yellow Yellow
continuous power
12 Yellow
supply
15 switched power supply Red
When the positions of the red and yellow
leads are inverted
Red Red
Yellow Yellow
12 switched power supply Yellow
continuous power
15 Red
supply
When the car without ACC position
Red Red
Yellow
Yellow
After matching the connections and switching
power supply leads correctly, connect the unit to
the car's power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.
Using the wired remote control
1
To enable the wired remote control, set
[STR CONTROL] in [SET STEERING] to
[PRESET] (page 19). .
20
Installation
Removing the protection collar and the
bracket
Before installing the unit, remove the protection
collar and the bracket from the unit.
1
Pinch both edges of the protection collar
, then pull it out.
2
Insert both release keys until they
click, and pull down the bracket
pull up the unit to separate.
Face the hook inwards.
Mounting the unit in the dashboard
Before installing, make sure the catches on both
sides of the bracket are bent inwards 2 mm (
in).
32
For Japanese cars, see "Mounting the unit in a
Japanese car" (page 36). .
1
Position the bracket inside the
dashboard, then bend the claws outward
for a tight fit.
182 mm (7
53 mm (2 1 / in)
8
Catch
2
Mount the unit onto the bracket
attach the protection collar
Notes
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Make sure the 4 catches on the protection collar
are properly engaged in the slots of the unit.
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
TOYOTA
Bracket
Existing parts supplied with
your car
NISSAN
, then
Bracket
Existing parts supplied with
your car
3 /
Note
To prevent malfunction, install only with the supplied
screws .
Fuse replacement
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
1 / in)
4
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
, then
.
to dashboard/center console
Bracket
to dashboard/center console
Bracket
Fuse (10 A)