Incoming Call Bearer +Cicb; Single Numbering Scheme +Csns - Multitech MTCBA-C-IP-N12 Reference Manual

Incoming Call Bearer +CICB

This specific command is used to set the type of incoming calls when no incoming bearer is given (see
Description:
+CSNS). The setting the +CICB command affects the current value of +CSNS.
Values: <mode>
Data
0
Fax
1
Speech
2
Data once (10 minute timeout)
3
Fax once (10 minute timeout)
4
Command syntax: AT+CICB=<mode>
Syntax:
Command
AT+CICB=1
Note: If no incoming bearer, force a fax call
AT+CICB=2
Note: If no incoming bearer, force a voice call
AT+CICB?
Note: Interrogate value
AT+CICB=?
Note: Test command

Single Numbering Scheme +CSNS

This command selects the bearer to be used when an MT single numbering scheme call is set up (see
Description:
+CICB, these commands are the same).
The setting the +CSNS command affects the current value of +CICB.
Note:
Values: <mode>
Data
0
Fax
1
Speech
2
Data once (10 minute timeout)
3
Fax once (10 minute timeout)
4
Command syntax: AT+CSNS
Syntax:
Command
AT+CSNS=0
Note: Force a data call
AT+CSNS=2
Note: Force a voice call
AT+CSNS?
Note: Interrogate value
AT+CSNS=?
Note: Test command
Multi-Tech Systems, Inc. CDMA Wireless AT Commands (PN S000294J)
Possible Responses
OK
Note: Command accepted
OK
Note: Command accepted
+CICB: 2
OK
Note: Default incoming bearer: voice call
+CICB: (0-4)
OK
Note: Speech, data or fax default incoming bearer
Possible Responses
OK
Note: Command accepted
OK
Note: Command accepted
+CSNS: 2
OK
Note: Default incoming bearer: voice call
+CSNS: (0-4)
OK
Note: Voice, data or fax default incoming bearer
Chapter 4 – Call Control Commands
25