Multitech MTCBA-C-EN-N1 User Manual page 39

On the
3. Packet Filters > DNAT Configuration
Source –
Pre DNAT Service –
Post DNAT IP –
Post DNAT Service –
Internal Source –
Click the Save button to save this configuration.
4. Save –
you have completed and submitted all the screens on which you have made changes. The
device will save all the settings and reboot the PC.
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375F)
Select the original target network/host of the IP packets that you now want rerouted.
The original target network/host is the one previously defined in the Network
Configuration section.
Any
Example:
Select the service for the Pre-DNAT destination. This service was just
defined in the Service Configuration section.
MeterPort
Example:
Select the destination to which the IP packets are to be diverted. Only one host
can be defined as the Post DNAT destination.
MeterIP
Example:
Select the service for the Post DNAT configuration.
MeterPort
Example:
Select the source address for packets that going to be sent. If you do not want
to change the address, select NOCHANGE.
NOCHANGE
Example:
Chapter 3 – Using the Web Management Software
screen, define the DNAT rule.
You must click Save and Restart once
Note:
39