Table of Contents
Advertisement
Assembly
cont.
Leak Check
WARNING
• Perform leak test outdoors.
• Extinguish all open flames.
• NEVER leak test when smoking.
• Do not use the mosquito trap until connection has been leak tested
and does not leak.
• Make 2-3 oz. of leak check solution (one part liquid dishwashing
detergent and three parts water).
• Apply several drops of solution at Cylinder Connection and Collar
Connection
If bubbles appear at connection, there is a leak.
• Disconnect, reconnect, and perform another leak check. If you continue
to see bubbles after several attempts, cylinder or Regulator may be
defective and should be replaced.
If NO bubbles appear at connections, the connections are secure.
CAUTION
Do not tamper with the regulator or use any substitute regulator.
Cylinder Connection
Cylinder
Connection
NOTE: Whenever either gas connection is loosened or removed, you
must perform a leak test.
Step 6
Press stakes into
ground through holes
in plastic feet on trap.
This reduces the risk
of the trap being
knocked or blown
over.
Collar Connection
Collar
Connection
Step 7
CAUTION
Contents of octenol cartridge are harmful if swallowed. Wash hands
before eating, drinking, chewing gum, using tobacco or using bath-
room facilities. Avoid contact with inside surface of foil package.
Open lid.
Remove Mosquito Deleto
TM
octenol lure refill from foil package.
Step 8
Remove the waxed paper from
the adhesive trap.
Note: Adhesive surface must
face toward outside.
Position edge of Adhesive Trap
over Tray Rails (typical both
edges).
Install lure into unit with
holes facing center of trap.
Edge of
Adhesive Trap
Tray Rail
5
Advertisement
Table of Contents
