Advertisement
Assembly
cont.
Step 8
cont.
n Install one adhesive trap into back of unit and one adhesive trap into front
of unit.
Back of unit
Helpful Tip:
On hot days, the waxed paper will remove easily if the adhesive trays are
cool. Store traps indoors.
Operation
• CARBON MONOXIDE HAZARD
• For outdoor use only. Never use inside house, or other
unventilated or enclosed areas. This unit consumes air
(oxygen). Do not use in unventilated or enclosed areas to
avoid endangering your life.
• EXPLOSION - FIRE HAZARD
• Never store propane near high heat, open flames, pilot lights,
direct
sunlight, other ignition sources or where temperatures
exceed 120
• Propane is heavier than air and can accumulate in low places. If
you smell gas, leave the area immediately.
• Never install or remove propane tank while unit is operating, near
flame, pilot lights, other ignition sources or while unit is hot to
touch.
• This unit is hot during use and can ignite flammables. Keep gaso-
line and other flammable liquids and vapors well away from unit.
• The propane tank must always be stored outdoors in a well ventilat-
ed space. Never store propane tank in an enclosed area (house,
garage, etc.). If unit is to be stored indoors, disconnect the propane
tank for out door storage.
6
Front of unit
DANGER
DANGER
degrees F (49°C).
Operation
cont.
• Do not attempt to operate until you have read & understand all
General Safety Information in this manual and all assembly is
complete.
• After lighting the unit for the first time it is normal to see some smoke
coming from the burner area. This smoke is the result of the burning
of residual oils from the manufacturing process. The smoke will disap-
pear within 10-15 minutes.
Lighting Instructions
1. Press and hold RED
IGNITOR B U T T O N
(until ignition is verified
in Step 3 of Lighting
Instructions below).
2. Push BURNER VALVE
in slightly & turn
to ON
posi-
tion. If starting
the unit for the first
Burner
time it will require 30-
Valve
60 seconds before
igniton can be verified
in Step 3 of Lighting
Instructions below.
3. Verify ignition by observing gauge:
Start Up
If the needle enters
the red zone (HOT)
on the gauge immedi-
ately turn the unit off
& call Coleman at
1-800-835-3278.
3-5 minutes (Normal)
Advertisement
