Making Settings For Connecting To The Smart Device; Making Wi-Fi Settings From The Control Panel; Making Wi-Fi Settings Using Push Button Setup (Wps) - Epson DS-80W User Manual

User's Guide

Making Settings for Connecting to the Smart Device

You can use the scanner from a smart device when you connect the scanner to the same Wi-Fi network (SSID) as
the smart device. To use the scanner from a smart device, access the following website, and then enter the product
name. Go to Setup, and then start setting up.
http://epson.sn
Access to the website from the smart device that you want to connect to the scanner.

Making Wi-Fi Settings from the Control Panel

You can make network settings from the scanner's control panel. After connecting the scanner to the network,
connect to the scanner from the device that you want to use (computer, smart phone, tablet, and so on.)
Related Information
"Making Wi-Fi Settings Using Push Button Setup (WPS)" on page 21
&
"Making Wi-Fi Settings by PIN Code Setup (WPS)" on page 22
&
"Making Wi-Fi Direct (Simple AP) Connection Settings" on page 23
&

Making Wi-Fi Settings Using Push Button Setup (WPS)

You can automatically set up a Wi-Fi network by pressing a button on the wireless router. If the following
conditions are met, you can set up by using this method.
❏ The router is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the router.
1. Make sure that the scanner is turned on.
2. Set the switch on the scanner to on.
3. Hold down the WPS button on the router until the security light flashes.
Important:
c
You must complete Wi-Fi connection setup within two minutes.
Network Settings
21