Motorola DCT5100 Quick Start page 2

Be sure to allow adequate ventilation and airflow around the DCT5100 to prevent overheating.
Position the DCT5100 with at least
2 inches of space above
and on all sides.
Do not block the slots and
openings in DCT5100.
Do not place anything on top
of the DCT5100.
Use the on-screen display menu to configure your video display and closed caption settings.
To access your configuration settings, press the MENU key on the
front panel or your remote control while the DCT5100 is turned off.
If your TV is on, the on-screen display menu appears listing the settings
you can configure. The user settings will also be displayed on the
front panel LED whether your TV is off or on.
When you first access the on-screen display, your TV screen may appear
blank if your DCT5100 is not set at the correct video display format.
You can still view your settings on the front panel LED (see below).
Before calling your service provider, review the troubleshooting guide.
This information is to help you quickly solve the problem. If your problem still exists, contact your service provider.
Problem
No sound
No picture
Picture or sound is noisy
on one channel
Sound from only one
stereo speaker
No power
Remote control
does not work
Poor audio quality
V E N T I L A T E
2
i n c h
Cause
Accidentally pressed MUTE on the remote control.
The stereo is tuned to the wrong entertainment component.
You are watching TV using your VCR, and your VCR is off.
Cable signal may not be reaching your home.
Coaxial cable is disconnected or loose.
Cable connections are disconnected or loose.
Power cord is disconnected.
Remote isn't set in cable TV mode.
Obstruction between remote and cable terminal.
Dead batteries.
Audio levels on external devices not set
relative to DCT5100 volume level.
2
i n c h s p a c e
Use your remote control or the cursor keys on the front panel
to navigate the on-screen display:
- Press the and keys to highlight the settings you wish to change.
- Press the key to select an option for that setting.
- To exit the setting and move to another setting, use the
When you are finished configuring your settings turn the DCT5100 back on.
For more information on configuration settings, refer to the DCT5100 User Guide.
Use key to highlight CLOSED CAPTION
Possible Solution
Press MUTE on the remote control to restore the volume level.
Check that the stereo is looking at the proper input source.
Turn your VCR on.
Check to be sure that all cables are connected properly and that your TV is tuned to the cable channel 3 or 4.
Hand-tighten the cable connections if necessary.
If connected through the baseband RCA video connection, make sure the cables are connected properly.
If you are watching TV using your VCR, be sure your VCR is on.
Ensure that the proper video display format for your TV has been selected.
Reconnect the cable and hand-tighten if loose.
Hand-tighten or reconnect the cables properly.
Ensure that wires are not frayed and plugs are not bent or broken.
Reconnect the power cord.
Ensure that the DCT5100 is plugged into an outlet that is always live.
Press CABLE on the remote control.
Ensure that nothing is on the DCT5100 or blocking a clear line of sight between it and the remote control.
Change the batteries in your remote control according to the instructions in the section, "Installing Batteries."
For best audio quality, use the remote control to set the DCT5100 to approximately ¾ of maximum volume level
and then adjust the audio levels on the external devices.
Do not position the DCT5100 in an
enclosed space that would restrict
airflow around the unit.
2
i n c h
Do not position the DCT5100 near
any external heat source that could
raise the temperature around the unit.
and
Use key to highlight SAVE CHANGES
Use key to select option Use key to select option
CLOSED CAPTION
DISABLE CANCEL CHANGES
ENABLE SAVE CHANGES
keys.