Motorola DCT5100 Setup Manual page 7

Connecting the DCT5100 to a High-Definition TV – Audio Only
TO
TV/VCR
Cable/
Antenna IN
This diagram shows the primary audio
connection from your DCT5100 to your
HDTV. You should use this configuration
only if your HDTV has built-in speakers
and you do not intend to include a stereo
or Home Theater receiver in
your configuration.
HPNA
IR
CABLE
USB
IN
HDTV
Video 1 Video 2
Video 3
Y
S-Video
Pb
Video
Pr
R R R
Audio
L L L
Connector cables to be used: Two-pronged RCA type audio cable (red & white)
1. Locate the AUDIO OUT L (white) & R (red) outputs on the DCT5100 and the AUDIO IN L & R inputs on your HDTV.
2. Using a two-pronged RCA type audio connector, connect the L (white) output on the DCT5100 to the L (white) input
on your HDTV. Do the same for the red.
If your HDTV offers digital audio inputs you may use the SPDIF or Optical SPDIF outputs on the DCT5100 to connect
the audio.
AUDIO IN VIDEO
R L SPDIF IN OUT
S-VIDEO
TV
Pass Card
R L
Y Pb Pr
AUDIO
OPTICAL
OUT
SPDIF
DCT5100
IEEE 1394
SWITCHED
105/125V
60Hz
4A MAX
CONVENIENCE
500W MAX
OUTLET
Do not plug the DCT5100 power cord into a wall
outlet until you have completed all connections
between the DCT and other components.