To Activate; To Set A Desired Speed; To Vary The Speed Setting - Fiat 500L 2019 Owner's Manual

186 STARTING AND OPERATING

To Activate

Push the On/Off button to activate the Speed Control. The
cruise indicator light in the instrument cluster display will
illuminate. To turn the system off, push the On/Off button
a second time. The cruise indicator light will turn off. The
system should be turned off when not in use.
WARNING!
Leaving the Speed Control system on when not in use
is dangerous. You could accidentally set the system or
cause it to go faster than you want. You could lose
control and have an accident. Always leave the system
off when you are not using it.

To Set A Desired Speed

Turn the Speed Control on. When the vehicle has reached
the desired speed, push the SET (+) or SET (-) button and
release. Release the accelerator and the vehicle will operate
at the selected speed.
NOTE: The vehicle should be traveling at a steady speed
and on level ground before setting the speed.

To Vary The Speed Setting

To Increase Speed
When the Speed Control is set, you can increase speed by
pushing the SET (+) button.
The driver's preferred units can be selected through the
Uconnect settings if equipped. Refer to "Uconnect Set-
tings" in "Multimedia" for more information. The speed
increment is dependent on the selected speed unit of U.S.
(mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the SET (+) button once will result in a 1 mph
increase in set speed. Each subsequent tap of the button
results in an increase of 1 mph.
• If the button is continually pushed, the set speed will
continue to increase until the button is released, then the
new set speed will be established.
Metric Speed (km/h)
• Pushing the SET (+) button once will result in a 1 km/h
increase in set speed. Each subsequent tap of the button
results in an increase of 1 km/h.