Table of Contents
Advertisement
the small print
battery use & safety
battery use & safety
IMPORTANT: HANDLE AND STORE BATTERIES PROPERLY TO AVOID INJURY OR
DAMAGE. Most battery issues arise from improper handling of batteries, and particularly from
the continued use of damaged batteries.
DON'Ts
• Don't disassemble, crush, puncture, shred, or otherwise attempt to change the
form of your battery.
• Don't let the phone or battery come in contact with water. Water can get into the
phone's circuits, leading to corrosion. If the phone and/or battery get wet, have them
checked by your carrier or contact Motorola even if they appear to be working properly.
• Don't allow the battery to touch metal objects. If metal objects, such as jewelry,
stay in prolonged contact with the battery contact points, the battery could become
very hot.
• Don't place your battery near a heat source. Excessive heat can damage the
phone or the battery. High temperatures can cause the battery to swell, leak, or
malfunction. Therefore:
• Do not dry a wet or damp battery with an appliance or heat source, such as a hair dryer or
microwave oven.
• Avoid leaving your phone in your car in high temperatures.
DOs
• Do avoid dropping the battery or phone. Dropping these items, especially on a hard
surface, can potentially cause damage.
• Do contact your service provider or Motorola if your phone or battery has
been damaged from dropping or high temperatures.
IMPORTANT: USE MOTOROLA ORIGINAL PRODUCTS FOR QUALITY ASSURANCE AND
SAFEGUARDS. To aid consumers in identifying authentic Motorola batteries from non-original
or counterfeit batteries (that may not have adequate safety protection), Motorola provides
holograms on its batteries. Consumers should confirm that any battery they purchase has a
"Motorola Original" hologram.
Motorola recommends you always use Motorola-branded batteries and chargers.
Motorola mobile devices are designed to work with Motorola batteries. If you see a message on
Invalid Battery
your display such as
or
• Remove the battery and inspect it to confirm that it has a "Motorola Original"
hologram;
• If there is no hologram, the battery is not a Motorola battery;
• If there is a hologram, replace the battery and retry charging it;
• If the message remains, contact a Motorola Authorized Service Center.
Important: Motorola' s warranty does not cover damage to the phone caused by non-Motorola
batteries and/or chargers.
Warning: Use of a non-Motorola battery or charger may present a risk of fire, explosion, leakage,
or other hazard.
PROPER AND SAFE BATTERY DISPOSAL AND RECYCLING
Proper battery disposal is not only important for safety, it benefits the environment. Consumers
may recycle their used batteries in many retail or service provider locations. Additional
information on proper disposal and recycling may be found on the Web:
• www.motorola.com/recycling
• www.rbrc.org/call2recycle/ (in English only)
Disposal: Promptly dispose of used batteries in accordance with local regulations.
Contact your local recycling center or national recycling organizations for more
information on how to dispose of batteries.
Warning: Never dispose of batteries in a fire because they may explode.
service & repairs
If you have questions or need assistance, we're here to help.
Go to www.motorola.com/consumer/support, where you can select from a number of
customer care options. You can also contact the Motorola Customer Support Center at 1-800-
331-6456 (United States), 1-888-390-6456 (TTY/TDD United States for hearing impaired), or 1-
800-461-4575 (Canada).
Specific Absorption Rate Data
SAR Data
This model wireless phone meets the government's
requirements for exposure to radio waves.
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to
exceed limits for exposure to radio frequency (RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government and by the Canadian regulatory authorities. These
limits are part of comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on standards that were developed by independent
scientific organizations through periodic and thorough evaluation of scientific studies. The
standards include a substantial safety margin designed to assure the safety of all persons,
regardless of age or health.
Unable to Charge
, take the following steps:
The exposure standard for wireless mobile phones employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set by the FCC and by the Canadian regulatory
1
authorities is 1.6 W/kg.
Tests for SAR are conducted using standard operating positions accepted
by the FCC and by Industry Canada with the phone transmitting at its highest certified power level
in all tested frequency bands. Although the SAR is determined at the highest certified power level,
the actual SAR level of the phone while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station, the lower
the power output.
Before a phone model is available for sale to the public in the U.S. and Canada, it must be tested
and certified to the FCC and Industry Canada that it does not exceed the limit established by each
government for safe exposure. The tests are performed in positions and locations (e.g., at the ear
and worn on the body) reported to the FCC and available for review by Industry Canada. The
highest SAR value for this model phone when tested for use at the ear is
worn on the body, as described in this user guide, is
differ among phone models, depending upon available accessories and regulatory requirements).
While there may be differences between the SAR levels of various phones and at various
positions, they all meet the governmental requirements for safe exposure. Please note that
improvements to this product model could cause differences in the SAR value for later products; in
all cases, products are designed to be within the guidelines.
Additional information on Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications & Internet Association (CTIA) Web site:
http://www.phonefacts.net
or the Canadian Wireless Telecommunications Association (CWTA) Web site:
http://www.cwta.ca
1. In the United States and Canada, the SAR limit for mobile phones used by the public is
1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a
substantial margin of safety to give additional protection for the public and to account for
any variations in measurements.
2 The SAR information includes the Motorola testing protocol, assessment procedure, and
measurement uncertainty range for this product.
Safety and General Information
Safety Information
This section contains important information on the safe and efficient operation of your
mobile device. Read this information before using your mobile device.
Exposure to Radio Frequency (RF) Energy
Your mobile device contains a transmitter and receiver. When it is ON, it receives and transmits RF
energy. When you communicate with your mobile device, the system handling your call controls
the power level at which your mobile device transmits.
Your Motorola mobile device is designed to comply with local regulatory requirements in your
country concerning exposure of human beings to RF energy.
Operational Precautions
For optimal mobile device performance, and to be sure that human exposure to RF energy does not
exceed the guidelines set forth in the relevant standards, always follow these instructions and
precautions.
Product Operation
When placing or receiving a phone call, hold your mobile device just like you would a landline
phone.
If you wear the mobile device on your body, always place the mobile device in a Motorola-supplied
or approved clip, holder, holster, case, or body harness. If you do not use a body-worn accessory
supplied or approved by Motorola, keep the mobile device and its antenna at least 2.5 centimeters
(1 inch) from your body when transmitting.
Using accessories not supplied or approved by Motorola may cause your mobile device to exceed
RF energy exposure guidelines. For a list of Motorola-supplied or approved accessories, visit our
Web site at: www.motorola.com.
RF Energy Interference/Compatibility
Nearly every electronic device is subject to RF energy interference from external sources if
inadequately shielded, designed, or otherwise configured for RF energy compatibility. In some
circumstances your mobile device may cause interference with other devices.
Follow Instructions to Avoid Interference Problems
Turn off your mobile device in any location where posted notices instruct you to do so.
In an aircraft, turn off your mobile device whenever instructed to do so by airline staff. If your
mobile device offers an airplane mode or similar feature, consult airline staff about using it in
flight.
Implantable Medical Devices
If you have an implantable medical device, such as a pacemaker or defibrillator, consult your
physician before using this mobile device.
Persons with implantable medical devices should observe the following precautions:
1.4
W/kg, and when
0.77
W/kg. (Body-worn measurements
2
Advertisement
Table of Contents
