Arming The System; Silent Arming - Code Alarm CA 110 Owner's Manual

Your System has many features and available options some of which are
selected at time of installation. Consult your installing dealer for options that
may have been installed and are not listed.

ARMING THE SYSTEM:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and release the LOCK button of your key chain transmitter one time.
The parking lights will flash once, the siren will chirp once, and the dash
mounted LED will begin to flash slowly confirming the system is armed. If you
have the optional door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood lid ajar. Simply close the opened entry point to provide full protection. If
the siren/horn did not sound when arming, then the chirps have been turned
off and you should refer to the section titled "ELIMINATING THE ARM/DISARM
CHIRPS" in this manual.

SILENT ARMING:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
2. Press and hold both buttons of your key chain transmitter for 2 seconds.
The parking lights will flash once, and the dash mounted LED will begin to
flash slowly confirming the system is armed. The siren will not chirp. If you
have the optional door lock/unlock circuit installed, the doors will lock.
NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood lid ajar. Simply close the opened entry point to provide full protection.
Page 2