Page 1
NAKTO ELECTRIC BICYCLE LCD display Control Panel Instruction Model No:861-A Working Voltage:DC24V or 36V(default) or 48V wiring: Red(D+): hot Black(GND):Neutral Blue(DS):switch for controller Yellow(DD+):positive wire for light Green(RX):Communication receiving White(TX):Communication sending expandable:PWM PAS level controlling by Voltage ,separate speed sensor Introduction for display marks: 1.
Page 2
2. Currency Level Status (need support with certain model controlers) 3. Voltage Level Status 4. Multi-functional display Area Total Trip “ODO”, Single Trip “TRIP”, Voltage “VOLT”, Currency “CURRENT”, Remaining Travelling distance(need support by battery protection software), Remaining Travelling time “TIME”. 5.
Page 3
start; P10:Powering Model settings: 0 : PAS(throttle disabled, output power is corresponding to PAS levels)。 1 : Throttle(PAS disabled, output power is controlled by throttle turning, top speed it corresponding to PAS level settings)。 2 : PAS & Throttle(In P9, the setting has to be 1)。 P11:PAS sensitivity:...
Page 4
Press and hold both buttons to enter into settings: to switch between settings, press Press increase the figures and to decrease the figures. Press to reserve the settings. While finish setting, just leave it for 10 sec, it will exit setting models.