Advertisement
Available languages
Available languages
Quick Links
DWWB005 Installation Manual
For OEM integration only – device cannot be sold to general public.
Therefore we will ask OEM to include the following statements required
by FCC on the product and in the Installation manual Notice.
Contents
1.Land Pattern(Recommended)
2.Supply Voltage
3.Pin configuration
4.Notice
(
)
1
Advertisement
Summary of Contents for Denso DWWB005
- Page 1 DWWB005 Installation Manual For OEM integration only – device cannot be sold to general public. Therefore we will ask OEM to include the following statements required by FCC on the product and in the Installation manual Notice. Contents 1.Land Pattern(Recommended) 2.Supply Voltage...
- Page 2 1 Land Pattern(Recommended Unit:mm) 1.Land Pattern(Recommended Unit:mm)
- Page 3 2. Supply Voltage Typ.[V] Min.[V] Max.[V] VBAT 1.65 1.92 Please supply a stabilized power supply voltage through the VBAT And VIO. pp y pp y...
- Page 4 3. Pin configuration...
- Page 5 4. Notice Please describe the following warning on the final product which contains this module. Contains Transmitter Mobile FCC ID:PZWDWWB005 Contains Transmitter Mobile FCC ID:PZWDWWB005 Contains FCC ID:PZWDWWB005 Contains FCC ID:PZWDWWB005...
- Page 6 Please describe the following warning to the manual. When installing it in a portable equipment [ Model Name ] Note) Portable equipment : Equipment for which the spaces between human body and antenna are used within 20cm. Mobile equipment : Equipment used at position in which the spaces between human body and antenna exceeded 20cm. ...
- Page 7 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 8 2) Module approval valid only when the module is installed in the tested host or compatible series of host which have similar RF exposure characteristic with equal or larger antenna separation distance. As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or co- location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used...
- Page 9 Industry Canada statement: This device complies with RSS-247 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received including This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Page 10 The product can be kept as far as possible from the user body or set the device to lower output power if such function is available. The final end product must be labeled in a visible area with the following: “Contains IC: 1551C-DWWB005”.
- Page 11 Manuel d'information à l'utilisateur final L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer ç ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué...