Table of Contents
Advertisement
Lamp replacement
This projector is equipped with a lamp to project images. This lamp is
a consumable. It may burn out or its brightness may decrease during
use. In such cases, replace the lamp with a new one as soon as possi-
ble. Be sure to replace the lamp with a new lamp separately sold that
is exclusive to this projector. Contact your dealer for purchase of the
lamp.
Replace the spare lamp using the lamp attachment unit that is
equipped with the spare lamp (separately sold) designed specifically
for this projector.
Spare lamp for EX52U: VLT-XD520LP
Caution:
•
Do not remove the lamp immediately after using the projector. You
may get burned because the lamp very hot after use.
•
Before replacing the lamp, press the POWER button to turn off the
lamp and wait for two minutes for lamp to cool down. Unplug the
power cord from wall outlet and wait one hour for the lamp to cool
down completely.
•
Do not remove the lamp except for replacement. Careless han-
dling can cause injury or fire.
•
Do not touch the lamp directly. It may break and cause injury or
burn.
•
Be sure not to drop the lamp lid screw into the projector. Also be
sure not to put metal or any flammable objects inside because it
may cause fire or electric shock. If any objects should fall inside,
unplug and contact your dealer.
•
Install the lamp securely to prevent failure and fire.
•
If the lamp should break, small glass fragments may fall out
through the grilles and some may remain inside of the projector or
the lamp box. When taking the lamp box out, be sure to turn over
the projector and hold the handle of the lamp box to avoid injury
due to the glass fragments.
•
If the lamp should break, never shake the lamp box or hold it in
front of your face after removing it. The lass fragments may fall out
and cause injury to your eyes.
•
Be sure to use the lamp dedicated to this projector, VLT-XD520LP
for EX52U. Use of other lamps may cause a failure of the projector.
•
Do not use any other tools for replacing the spare lamp, and be
sure to use the lamp attachment unit that is equipped with the
spare lamp (separately sold) designed specifically for this projec-
tor. Use of other tools may cause a failure of the projector.
The lamp unit is fixed in position with two retaining claws (a) inside so
the lamp attachment unit (b) designed specifically for this projector is
required to replace the lamp.
Do not pull out the lamp forcibly. The lamp unit may be irretrievably
damaged.
A new lamp unit can be installed without the lamp attachment unit.
(a)
1. Remove the screw (c) and slide the lamp cover (d) for removal.
(c)
• Make sure that the projector is securely held in place.
2. The three screws are in the holes indicated by the arrows sepa-
rately.
(b)
(d)
Loosen the three screws (e) using a Phillips screwdriver (+).
3. Mount the lamp attachment unit (b).
(Caution)
When replacing the lamp, do not remove the screws other than
those in the above picture. (Don't absolutely remove the screw
marked with circle in the below picture. )
If do, it might cause the failure of product.
(b)
When the projector is mounted to the ceiling:
Secure the lamp attachment unit and the projector with the screw
(f) that come with the lamp attachment unit. Otherwise, the lamp
unit may fall from the inside and cause injuries.
• Contact your dealer when replacing the lamp unit with the pro-
jector mounted to the ceiling.
(e)
(f)
EN-25
Advertisement
Table of Contents
