Assembly And Installation - Barazza 1KCYP9 Use And Maintenance Instructions

connection ring.
• CAUTION! For this type of installation, if the
hood is equipped with charcoal filter/s, this /
these must be removed.
• Connect the hood to pipes and wall exhaust
holes having the same diameter as the air outlet
(connection flange) one. The use of pipes and
wall exhaust holes with a smaller diameter will
result in a reduction in air flow performance
and a drastic increase in noise levels. Thus, we
hereby decline all liability in this regard.
• Use the shortest duct possible. In horizontal
sections, the pipe must have a slight inclination
(approx. 10%) to better convey the air towards
the outside of the room.
• Use a duct with as few bends as possible
(maximum bend angle: 90 °).
• Avoid abrupt changes in the duct cross-
section.
Only for Germany: When the cooker
hood and appliances powered by energy
other than electricity
simultaneously, the negative pressure in
the room must not exceed 4 Pa (4 x 10-5
bar).
Recycling version
(for some products / models it may be necessary
to purchase an optional kit).
*
CAUTION! It is recommended to use
this installation version ONLY with a gas-
powered hob.
*
CAUTION! The
function/feature may NOT give expected
results in this operation mode.
Grease and odors will be removed from
extracted air before returning it back into the
room. To use the hood in this mode , you need
to fit an additional charcoal filter-based filtering
system, if not present.
ELECTRICAL CONNECTION
The main voltage must correspond to the
voltage indicated on the rating label found
inside the hood. If the hood is provided with
are operated
anti-condensation
en es
a plug, connect the hood to a socket that
complies with current regulations, which needs
to be found in an area that is reachable even
after installation. If the hood is not equipped
with a plug (direct connection to the mains) or
the plug is placed in an unreachable area, even
after installation, fit a two-pole switch compliant
with current regulations, which
complete disconnection from the mains
under overvoltage category III conditions, in
accordance with installation rules.
CAUTION! Before reconnecting the hood
circuit to the power supply and verifying its
proper operation , always check that the mains
able has been fitted correctly. The hood is
equipped with a special power cord; if the cord
is damaged, contact the technical assistance
service .

ASSEMBLY AND INSTALLATION

Before starting installation:
• Check that the purchased product is of a
suitable size for the installation area selected.
• Remove the activated charcoal filter (s) if
supplied (see also related paragraph). This/
these must be refitted only if the hood is
to be used in the recycling version.
• Check that there is no accompanying
material (for transport purposes ) inside the
hood (for example, plastic bags with screws,
guarantees, etc.), which may need to be
removed and stored for use.
CAUTION! As the product is of excessive
weight, handling and installation of the hood
must be done by at least two or more persons.
CLEANING AND MAINTENANCE
ONLY use a cloth moistened with neutral liquid
detergent for cleaning the hood . DO NOT
USE TOOLS OR OTHER INSTRUMENTS
FOR CLEANING operations! Avoid using
products containing abrasives. DO NOT USE
ALCOHOL!
28 28
ensures