AEG LR73R864 User Manual page 16

16 www.aeg.com
8.5 Vlekken/Voorw. - Taches/
Prélav.
Press this button repeatedly to activate
one of the two options.
The relevant indicator goes on in the
display.
• Taches - Vlekken
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
will be added in the appropriate phase
of the washing programme.
This option is not
available with a
temperature lower than
40 °C.
• Voorwas - Prélavage
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
solid particles.
The options can increase the
programme duration.
8.6 Extra
With this button you can select one of the
following options:
• Skipping wash phase - Alleen
spoelen - Rinçage option
The appliance performs only the
rinsing phase, the spinning and the
draining phases of the selected
programme. When this option is set
the washing phase is not performed.
• Centrif./Pompen - Essorage/
Vidange option
The appliance performs only final
spinning or only draining phase of
selected programme. By selecting No
Spin
Essorage button only Drain cycle can
be configured.
. The stain remover
option via Centrifugeren -
The corresponding indicator above the
touch button illuminates.
8.7 Extra Spoelen - Rinçage
plus
With this option you can add a few rinses
according to the selected washing
programme.
Use this option for people with allergies
to detergent residues and with sensitive
skin.
This option increases the
programme duration.
The related indicator comes on.
8.8 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme. The steam
phase reduces fabric creasing and
facilitates the fabric ironing.
The drum performs smooth movements
for about 30 minutes. The duration of the
steam phase changes accordingly to the
selection. When Plus Steam option is set
the programme ends up with an
anticrease phase during which the drum
is occasionally rotated to prevent
wrinkling. The display shows
indicator is steady on and the
indicator starts flashing. Start/Pauze -
Départ/Pause button is lit as well. At the
end of the anticrease phase the drum
definitely stops, the indicator goes off,
the door unlocks. User at any moment
can terminate the anticrease phase by:
• pressing the Aan/Uit - Marche/Arrêt
button for a few seconds to activate or
deactivate the appliance;
• turning the selector knob to another
position.
A small laundry load helps to
reach better results.
8.9 Tijd besparen - Gain de
temps
With this option you can decrease the
programme duration.
the