Loop Handle Version; U-Handle Version - Echo SRM-3021TES Operator's Manual

Before you start

Loop handle version

Loop handle assembly

U-handle version

U-handle assembly
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
E: Arrow
 Install the handle to the engine side from the arrow
mark.
1. Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (B) and fix handle by tightening
handle assembling bolt (C) lightly.
2. Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
 To adjust the fixture bolt (D) proceed (As needed)
(1) Tighten the bolts until snug.
(2) Loosen the bolts 1
E: Arrow
F: To engine
 Install the handle to the engine side from the arrow
mark.
3. To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
 After assembly, adjust the play of wire end (J) on carbu-
rettor (L) side to 1 mm - 2 mm.
K: Nuts
10
F: To engine
CAUTION
1
/ turn.
2
CAUTION
CAUTION