Advertisement
TROUBLESHOOTING (continued)
PROBLEM
If the light Stays on
If the light flashes or blinks
Light will not go on or off
In Manual override, the light
is not stayed on at dusk
If unable to fix any of the above issues, please consult a certified electrician.
FIVE-YEAR LIMITED WARRANTY: If, during normal use, this PATRIOT LIGHTING lighting fixture breaks or fails
due to a defect in material workmanship within five (5) years from the date of original purchase, simply bring this
lighting fixture with the original sales receipt back to your nearest MENARDS retail store. At its discretion, PATRIOT
LIGHTING agrees to have the product or any defective part(s) repaired or replaced with the same or similar PATRIOT
R
LIGHTING product or part free of charge, within the stated warranty period, when returned by the original purchaser
R
with original sales receipt. This warranty; (1) excludes expendable parts including but not limited to light bulbs; (2) does
not cover damage that has resulted from abuse or misuse; and (3) does not cover any losses, labor, injuries to
persons/property or costs. This warranty does give you specific legal rights and you may have other rights, which vary
from state to state.
POSSIBLE CAUSE
The SENSITIVITY may be set too high.
Motion detector lens may be installed upside
down.
The coverage area may be too large and the
motion detector is sensing unwanted motion.
There may not be enough light being
detected by the photocell.
The photocell maybe detecting light from
the lamp and could be responding as if
the light from the bulb were daylight.
Shut-off delay time is too short.
Too much light is shining onto sensor due to
another light source, such as a street lamp
or other light fixture.
Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 1-800-887-6326
Monday – Friday 9:00 a.m. – 5:00 p.m. CST
CORRECTIVE ACTION
Try reducing the SENSITIVITY in small
steps.
Gently pull lens out. The three drain
holes should be on the bottom.
Re-install in proper position.
Try adjusting the coverage dials on
either side of the motion detector lens
upward to reduce the coverage area.
On cloudy or overcast days, the light
may stay on longer than intended. No
corrective action needed.
Try lower wattage bulb.
To increase the shut-off delay time,
rotate the knob clockwise.
Eliminate or turn off other light source,
block other light source from shining
onto sensor, or relocate fixture.
R
R
Page 6 of 6
200818
Advertisement
