15.
Replace the power supply assembly by reversing the steps for removal.
Remember to replace the snipped tie wrap with the one provided in the
power supply FRU kit.
16.
Perform the applicable checkout procedures.
Refer to
Replacing the Acquisition Board Assembly
1.
Separate the middle plastic and base plastic assemblies as described in
"Replacing the Power Supply Assembly" on page
2.
Using the following illustration, identify the acquisition board assembly (1).
3.
Disconnect the gray USB connector from the acquisition board as shown
in the following illustration.
2028451-183E
"Functional Checkout" on page
MAC™ 1600
99.
72, steps
1
through 8.
Maintenance
75