Toro TITAN 121-5680 Installation Instructions

Spindle Kit
TITAN
Model No. 121-5680
Model No. 121-5681
Note: Determine the left and right sides of the machine from the normal operating position.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1
Preparing the Mower
No Parts Required
Procedure
1. Thoroughly clean mower deck. All debris must
be removed to ensure the spindle housing will fit
properly against mower deck.
2. Repair all bent or damaged areas of mower deck and
replace any missing parts.
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Zero-Turn-Radius Riding Mower
Description
No parts required
Spindle housing
Washer (.88 inch O.D.)
Register at www.Toro.com.
Qty.
–
Prepare the mower.
1
Install the spindle housing.
2
Installing the Spindle Housing
Parts needed for this procedure:
1 Spindle housing
Washer (.88 inch O.D.)
Procedure
WARNING
While maintenance or adjustments are being made,
someone could start the engine. Accidental starting
of the engine could seriously injure you or other
bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance. Also push
the wire(s) aside so it does not accidentally contact
the spark plug.
1. Park the machine on a level surface, disengage the
blade control switch, and move the motion control
levers outward to the neutral position and engage
parking brake.
2. Stop the engine and remove the key.
Form No. 3371-631 Rev A
Installation Instructions
Use
Original Instructions (EN)
Printed in the USA.
All Rights Reserved