Summary of Contents for Microtek ADF-600EL
- Page 1 Microtek Automatic Document Feeder INSTALLATION AND OPERATION MANUAL ADF-600L / ADF-600EL...
- Page 2 Important Documents you scan may be protected under copyright law. The unauthorized use of such documents could be a violation of the rights of the copyright holder. Microtek bears no responsibility for the unauthorized use of copyrighted materials. Microtek Lab, Inc.
-
Page 3: Table Of Contents
Contents 1 Introduction Overview ... 1 Applications ... 1 2 Installation Checkout ... 2 Before you Begin ... 2 Installation ... 3 3 Operation Paper Loading ... 5 Correcting Paper Jams ... 6 4 Maintenance Guide Flap Cleaning and Replacement ... 7 Roller Cleaning ... -
Page 4: Introduction
1 Introduction Overview The Automatic Document Feeder (ADF-600L / ADF-600EL) is a companion sheet feeder for Microtek's ScanMaker series scanners. It allows automatic scanning of up to 25 sheets, with dimension of the document as large as 8 1/2" x 14". Sheets to be scanned are fed from a stack in the Automatic Document Feeder's input tray, guided past the scanner's image sensor, and placed in the feeder's output tray. -
Page 5: Installation
Follow these steps before installing the Automatic Document Feeder: 1. Make sure the scanner's back panel has a 15-pin Automatic Document Feeder connector. Call Microtek if your scanner doesn't have one. 2. Install the scanner as described in your Installation Guide. -
Page 6: Installation
5. Press the Locking Button at the right side of Automatic Document Feeder. This will cause the transport module of Automatic Document Feeder to pop up a little. Automatic Document Feeder Installation and Operation Manual MICROTEK INTERNATIONAL INC. Pressing the Locking Button... - Page 7 8. Close the Automatic Document Feeder. Automatic Document Feeder Installation and Operation Manual Raising the Transportation Module Protective Film Guide Flap...
-
Page 8: Operation
3 Operation After installation of the Automatic Document Feeder is complete, power up the computer and the scanner, then start up the scanner software. Paper Loading Before loading the Automatic Document Feeder, check to see if the transparent guide flap is firmly attached in place and if the protective film is removed as described in Chapter 2. -
Page 9: Correcting Paper Jams
3. Lower the Automatic Document Feeder transportation module down, and snap to close it. Automatic Document Feeder Installation and Operation Manual Pressing the Automatic Document Feeder Locking Button... -
Page 10: Maintenance
Note: Do not attempt to turn the roller while cleaning it; this may damage the ADF's drive mechanism. Wiping the Guide Flap with a piece of ink-free cloth Cleaning the rollers Automatic Document Feeder Installation and Operation Manual... -
Page 11: Appendix: Specifications
Physical Weight Power Consumption Operating Conditions Automatic Document Feeder Installation and Operation Manual 25 sheets of copy bond paper (unfolded) 16 to 24 lb. bond paper Min. 5.5" x 5.5" Max. 8.5" x 14" (US Legal size) Paper screw: ±1º...