Sony MDS-SE9 Service Manual page 4

MDS-SE9
Self-diagnosis display
This system has a Self-diagnosis display
function to let you know if there is a system
malfunction. The display shows a code made up
of three or five letters and a message alternately
to show you the problem. To solve the problem
refer to the following list. If any problem
persists, consult your nearest Sony dealer.
C11/Protected
The MD is protected against erasure.
cRemove the MD and slide the tab to close the slot.
C12/Cannot Copy
You tried to record a disc with a format that the
system does not support, such as a CD-ROM.
cRemove the disc and turn off the system once,
then turn it on again.
You tried to record sound that cannot be digitally
recorded with this system from a connected optional
component.
cSwitch the digital audio output of the optional
component to PCM mode.
C13/REC Error
Recording could not be performed properly.
cMove the system to a stable place, and start
recording over from the beginning.
The MD is dirty or scratched, or the MD does not
meet the standards.
cReplace the MD and start recording over from the
beginning.
C13/Read Error
The MD deck cannot read the disc information
properly.
cRemove the MD once, then insert it again.
4
C14/TOC Error
The MD deck cannot read the disc information
properly.
cReplace the MD.
cErase all the recorded contents of the MD using
the All Erase Function.
C41/Cannot Copy
The sound source is a copy of a commercially
available music software or CD-R.
cThe Serial Copy Management System prevents
making a digital copy. In addition, you cannot
copy from a CD-R.
C71/Check OPT-IN
The digital optical cable is disconnected, or the
power of the connected component is turned off
while recording the digital audio from an optional
component connected to the VIDEO/SAT
DIGITAL IN OPTICAL jack or a CD.
cConnect the digital optical cable, or turn on the
power of the connected component.
The DVD player and the MD deck are not
connected correctly with the digital optical cable, or
you tried to start the recording immediately afte r
setting the recording pause mode when making a
digital recording from a optional component
connected to the VIDEO/SAT DIGITAL IN
OPTICAL jack or a CD.
cConnect the digital optical cable correctly, or wait
for several seconds in the recording pause mode
before starting the recording.
E0001/MEMORY NG
The component has internal problem.
cConsult your nearest Sony dealer.
E0101/LASER NG
There is a problem with the laser pickup.
cThe laser pickup may be damaged. Consult your
nearest Sony dealer.
E0201/LOADING NG
There is a problem with loading.
cConsult your nearest Sony dealer.