REMOTE DISPLAY PANE INSTALLATION AND OPERATION INSTRUCTIONS
APPROVALS
Nonhazardous Locations
KIT CONTENTS
Item Qty
Description
A
1
Display panel with mounting screws
B
1
Single duplex outlet cover plate with mounting screws
WARNING:
This unit should be installed, opened, and repaired by qualified
personnel only.
To avoid shock hazard, do not open the front cover with power
connected to the controller or any controlled equipment.
THERMAL BUILDING SOLUTIONS
ECW-GF-DP
Always open any circuit breakers and remove power from any high
voltage electrical circuits installed in close proximity to or sharing
an enclosure with the ECW-GF-DP prior to removing the enclosure
cover plate.
EN-RaychemECWGFDP-IM-H58410 03/15
DESCRIPTION
The Raychem ECW-GF-DP is a remote display panel only for the
Raychem ECW-GF electronic controller. The ECW-GF-DP allows
remote monitoring of the heating cable system operation. The
display has LED indicators which signal communication loss to the
controller, high/low temperature alarm, and temperature sensor
failure. The display also has buttons to test and reset the ground-
fault sensor. The display may be located up to 328 feet (100 m)
from the ECW-GF controller.
The ECW-GF-DP remote display panel must be installed in
conjunction with the ECW-GF controller. Refer to the ECW-GF
installation instructions (H58339) for further details.
For technical support, call Pentair Thermal Management at
(800) 545-6258.
TOOLS REQUIRED
• Large slotted screwdriver
• Small slotted screwdriver
ADDITIONAL MATERIALS REQUIRED
• Duplex junction box
• 1/2 inch conduit
• Communication cable: 8 conductor 22 AWG shielded
Alpha Cat. No. 1298C or equivalent
A
B
Read all instructions carefully before installation. Save this
Installation and Operation Instruction for future reference.
• Needle nose pliers
• Wire strippers
1 / 4