ZyXEL Communications NBG6515 User Manual page 16

Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the
3
anchors into the full depth of the holes, then insert the screws into the anchors. Do not
insert the screws all the way in - leave a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not
insert the screws all the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the NBG with the
4
connection cables.
Align the holes on the back of the NBG with the screws on the wall. Hang the NBG on the
5
screws.
Figure 2 Wall Mounting Example
Chapter 1 Getting to Know Your NBG
NBG6515 User's Guide
16